Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.


Extruding from edge of a part

rodrigo_martinellirodrigo_martinelli Member Posts: 7
edited September 2023 in Community Support
Hi, i'm trying to extrude a surface using the edges of a part, is that possible?
I hope the images are good enough, what i need to do is, extrude that edge 2mm normal to the face on the whole perimeter, then "inset it" and later, translate it since it's at an angle..

Link to the document:


Best Answer


Sign In or Register to comment.