Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:

  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Consecutive bends creeping closer

lourens_de_bruyn
lourens_de_bruyn Member Posts: 4 ✭
edited November 7 in Community Support

Hello
I am doing a sheet metal that is bent 5 times, each time with a 33mm flat section in between.
The bends are creeping exponentially closer together and does not keep to the line spacing.
Adjusting the hold line or the k factor has no effect.
How do I bend the sheet metal as indicated on the sketch?

Heat Shield V2 or
There was an error displaying this embed.

Tagged:

Answers