Stick fonts for engraved legends on panels

michael3424

I'd like to engrave text on an instrument panel in what I think is called a stick font, in the general form of the one below, but I don't see a font like this available in the Text Sketch feature.  Is it possible to use this sort of font in OS?

chrisjh777

Also known as Single Stroke Font.  

Please add "OLF Simple Sans OC" as well.

I requested this August 2016 and it was added to an improvement to allow users to  add your own fonts. See below:

lougallo (Onshape Support) Aug 15, 22:24 UTC Hi Chris, I have added you to an improvement to add your own fonts. ~Lou Your support ticket: "Single Stroke Font" has been marked as an improvement request. Onshape development will evaluate the request and we will notify you if/when this has been implemented. Thank you for helping us make Onshape awesome! Lou Gallo PD/UX/Support/Community Onshape, Inc. Join the Onshape Community

chrisjh777

Also known as Single Stroke Font.  

Please add "OLF Simple Sans OC" as well.

I requested this August 2016 and it was added to an improvement to allow users to  add your own fonts. See below:

lougallo (Onshape Support) Aug 15, 22:24 UTC Hi Chris, I have added you to an improvement to add your own fonts. ~Lou Your support ticket: "Single Stroke Font" has been marked as an improvement request. Onshape development will evaluate the request and we will notify you if/when this has been implemented. Thank you for helping us make Onshape awesome! Lou Gallo PD/UX/Support/Community Onshape, Inc. Join the Onshape Community

owen_sparks

I would very much like this too, probably for much the same reasons.

@lougallo, please will you add me to the request also?

Many thanks,
Owen S.

michael3424

@chrisjh777  - thanks for the heads up.  @lougallo, can you please add me to this as well?

agustin_gonzalez

I'd like to use my own fonts too.
Engraving panels means quite always the use of your own fonts for aesthetic reasons.
Add me to this request, please! 

GWS50

I have just finished a job where I needed to use the client's preferred font and unfortunately I had to use another CAD software to do this, which was disappointing to say the least.
I'm hoping that this request is moving up the improvement list