Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Export to DXF
kristoffer_falk
Member Posts: 23 ✭✭
When I export parts as DXF and import them in my CAM-software I don't get the entire part.
On the part below only the highlighted part will be exported. I presume that is due to the pocket in between the grey and yellow part.
Is there someway to solve this without the need of redesign?
Regards
Kristoffer
On the part below only the highlighted part will be exported. I presume that is due to the pocket in between the grey and yellow part.
Is there someway to solve this without the need of redesign?
Regards
Kristoffer
0
Answers