Frame trim
kevin_mason558
Member Posts: 70 PRO
I'm trying to trim three beams togetheri want two to meet the first and then to mitre to each other
I tried the ordered groups but the two diagonals won't splice together.
Tagged:
0
Best Answers
-
Try mitering the first two, first, then trim to the other. If that doesn't work you may just have to revert back to normal modelling features.Senior Director, Technical Services, EMEA0
-
As @NeilCooke said: Make the angled section with the frame tool, using the miter joint condition. Make the horizontal segment with another frame operation. Then use the trim to face to trim the mitered segments against the horizontal segment. Like so:
https://cad.onshape.com/documents/3678801b6365128570cec5da/w/0c9f8f6dc5d580acd104352e/e/9874f008ca748c105dc4f56d
0
Answers
-
Try mitering the first two, first, then trim to the other. If that doesn't work you may just have to revert back to normal modelling features.Senior Director, Technical Services, EMEA0
-
@NeilCooke how do I mitre them without selecting them in the same "frame"
found that difficult in past0 -
As @NeilCooke said: Make the angled section with the frame tool, using the miter joint condition. Make the horizontal segment with another frame operation. Then use the trim to face to trim the mitered segments against the horizontal segment. Like so:
https://cad.onshape.com/documents/3678801b6365128570cec5da/w/0c9f8f6dc5d580acd104352e/e/9874f008ca748c105dc4f56d
0 -
@jnewth_onshape thanks again.Similar to the post the other dayI have circular patterned a spoke that comes down into a pipe I trimmed it to the centre pipe
but wanted them to trim between themselves as well - as shown above
I trimmed each part to a plane now.0