Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.First time visiting? Here are some places to start:
- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Gears in Assembly
jože_marinko Member Posts: 4 ✭
Made some gears in Part Studio. Import gears in Assembly Tab and connect them with Revolute mates. Gears are different, so I must rotate them to put teeth together. OK. Then take a Gear mate, specify gear ratio - and gears turned to position before rotating.
NeilCooke Moderator, Onshape Employees Posts: 4,698When you add a relation, the mates "reset" - i.e. they go back to their original alignment with the mate connectors that were used. If you want to rotate a gear and modify it's "reset" position, edit the mate connector (located under the revolute mate) and add a Rotation about Z.Director, Technical Services, EMEA5
Try to connect Small Sun and Short Planet 1 with Gear mate (ratio 2) and you will see that this two gears will rotate !!!??? The teeth are NOT touching correctly. What to do?