How do you make a curved ramp?

will_vitola
will_vitola Member Posts: 3 ✭✭
in Community Support
I am trying to make a ramp above a semicircle that curves along its edge. I have spent the last several hours trying to figure this out so any help would be much appreciated! thanks!
Tagged:

Best Answer

Answers

  • NeilCooke
    NeilCooke Moderator, Onshape Employees Posts: 6,120 image
    More info is required but have you tried helix and sweep?
    Senior Director, Technical Services, EMEA
  • will_vitola
    will_vitola Member Posts: 3 ✭✭
    edited October 2019
    Helix or sweep might be the solution to my problem but if so I am not sure how to implement them.
    Maybe this will help clarify what I'm asking...

    This a top down view of my project so far, I am trying to make a slope or ramp that starts at line "A" and ends on line "B." The slope will rise upwards as it goes counterclockwise or follows the arrow. The ramp needs to stay between the lines that line "A" and "B' connect. Thanks again!!!


  • NeilCooke
    NeilCooke Moderator, Onshape Employees Posts: 6,120 image
    Answer ✓
    There are many ways to do it - here's one:

    https://cad.onshape.com/documents/b8d81f2f3d0c1e571820bb8c/w/7a57b684c288d06f1e623dd0/e/a548bd5761002abfa0824d9f


    Senior Director, Technical Services, EMEA
  • will_vitola
    will_vitola Member Posts: 3 ✭✭
    Thank you!

Categories