How does one design a bar like the attached one in Onshape?
ProApe
Member Posts: 396 ✭✭
Hi,
I'd like to know how to design such a bar, with a tongue at both ends in Onshape. How many sketches does one need?
Kind regards
Pro Ape
0
Best Answers
-
Senior Director, Technical Services, EMEA0
-
You asked how many sketches, so I said one
You cannot show dims in in iso view like that but you can lay it out in a traditional orthogonal 2d drawing.Senior Director, Technical Services, EMEA2
Answers
-
One.Senior Director, Technical Services, EMEA3
-
Senior Director, Technical Services, EMEA0
-
What do you mean by your message containing only the word "One"?Finally it's rather simple if you get it right, from the cross-section.Thank you.But is it possible to show all the dimensions as in my screenshot from Sketchup?
0 -
You asked how many sketches, so I said one
You cannot show dims in in iso view like that but you can lay it out in a traditional orthogonal 2d drawing.Senior Director, Technical Services, EMEA2