configurations

Hello Is it possible to drive a certain value in an assembly based on the input of (several) configuration variables. (or better yet, the chosen value in a configuration list input). best would be to drive variables that can be used throughout the assembly (but those are global variables or "variable studio variables" and…

Is there a way to drive/ select the insertion point of a frame/ beam element by configuration variable? 

I have a sprocket configuration that is reporting a variable as having failed to regenerate in the feature tree while it is fine in the physical model. I haven't found a similar forum post and am hoping someone here has an idea why, thanks in advance! Screenshot and link below.…

I am trying to configure a part number to depend on two List inputs. The part also has a configuration variable input, but I don't want the part number to depend on it. A strategy I have conceived to do this is something like the following. The part number would be configured in the configured properties table using a…

I am hoping someone can suggest a creative way that I can configure a sticker part to be either flat or wrapped onto a cylinder. The orientation of the cylinder axis should be configurable to at least horizontal and vertical. I do not want to create a different part for each topology change. This would be easy if I could…

I regularly rely on configurable parts to make changes in higher level assemblies without breaking mates. I have configured many parts and generally understand how to do so. However, I am struggling to figure out what the best architecture would be for creating a configurable tube. The properties that need to be configured…