Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:

Looking for a certain topic? Check out the categories filter or use Search (upper right).
Need support? Ask a question to our Community Support category.
Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

layout sketches

can't close a sketch profile using a spline
greetings, I have four splines. One makes a simple two point spline curve, the second is it's offset. The remaining two are 3 point splines enclosing the ends of the of the first two. I'm having a hard time getting one of the end splines to close for a profile. I use the coincident constraint when I start and end the…
Using part studio sketches in Assemblies
I have an assembly with 3 parts, Each in their own studio and imported. One of them has a sketch that is located and drawn according to several measurements off of that part. I want to use that sketch to cut the shape in the other two parts, but can not find any way to get the sketch to show up. I have been redrawing the…
How do I edit a sketch fillet?
You can change the radius of the arc of a fillet but it doesn't respond as a fillet it actually moves the connecting lines to a new position based on the original fillets centre point. Anyone know what I'm doing wrong, presumably its something to do with the constraints?

can't close a sketch profile using a spline
greetings, I have four splines. One makes a simple two point spline curve, the second is it's offset. The remaining two are 3 point splines enclosing the ends of the of the first two. I'm having a hard time getting one of the end splines to close for a profile. I use the coincident constraint when I start and end the…
Using part studio sketches in Assemblies
I have an assembly with 3 parts, Each in their own studio and imported. One of them has a sketch that is located and drawn according to several measurements off of that part. I want to use that sketch to cut the shape in the other two parts, but can not find any way to get the sketch to show up. I have been redrawing the…
How do I edit a sketch fillet?
You can change the radius of the arc of a fillet but it doesn't respond as a fillet it actually moves the connecting lines to a new position based on the original fillets centre point. Anyone know what I'm doing wrong, presumably its something to do with the constraints?

Discussion List