learning center exercise

Hello. In step 6 of Reducer Coupling, after performing all required procedures, I believe, this does not allow me to select a new sketch on the flat face of the revolution labeled as A, therefore, I can not proceed with the exercise ;(…

Hi, I'm currently following the Handle tutorial on the Surface Modeling course: https://learn.onshape.com/learn/course/onshape-surface-modeling/manipulating-surfaces/exercise-handle?page=2 I seem to be stuck trying to create the loft on steps 4 and 5, specifically selecting the guide curves. I'm not sure what I'm doing…

Specifically at Step 11 the student is instructed to: Double check the Feature list. There is one more feature that is red, the Base Fillets. Switch the configuration to the Square Base. Double check the Feature list, again. All the features should build without errors in this configuration. This not the case. When…

Hello, I'm new to onshape and learning it. I've been going through the course "Part Design Using Part Studios (Deprecated)" and recently completed the Exercise "Wheel Rim". But when I check the mass, mine doesn't match up with any of the answer choices provided at the self-check at the end of the exercise on the website. I…

Some of my students found a spelling mistake in the following location. Self-Paced Courses - CAD Basics --Introduction to Assembly Design ---03. Working with Assemblies ----Exercise: Assembly -----Slide 10 ------Anti-align to Z ....spelling mistake?...Anit is used instead of Anti. I have been having troubles getting the…