measurement

As far as I can tell there is no option for dual dimensions in the part studio sketches or within the measure tool. While searching for this function I found a forum post stating that onshape is working on it, and even a improvement request that was marked complete in 2021. However I cannot find dual dimensions in anything…

i am 3d model for a CFD study and i am trying to store my front surface in variable so i can access it easily and so i can calculate the drag coefficient of my model . I already have my front surface but i can't save the value

I am going to be designing something like the image above. It needs to be balanced around the pivot point. How to I check this is Onshape?

Selecting a cone with the measuring tool. Is there a way to get OnShape to display its volume? Ditto a cylinder.

I'm trying to figure out a way to model a flex circuit in its bent form and by controlling a dimension, end up with the flat pattern having the correct length. I can get something by trial and error which is close enough (a path length measurement in sketcher sure would help here). One frustration is that the custom…

How do I measure an angle between two faces on different parts in FeatureScript?

Essentially I'm trying to recreate a 'sensor' or User-Defined Measurement. In the simplest case I have an arc, would like to evaluate it's length, then store that number in a variable so that I can reference it later in my model tree. I'm just jumping into featurescript so it's not immediately obvious to me how to do this,…

I was almost certain that Onshape already had the capability to report the combined length of a chain of sketch entities (eg lines, arcs - not sure if it extended to chains including splines) once they were selected. In my recollection the readout at bottom right showed the aggregated length. I can't get that to work for…