section view
Discussion List
-
Section view measurement
Hi, I moved to Onshape from Solidworks few months ago. I have one question for measuring in the section view: If I have two or more parts intersecting each other, is there any way to measure how much they are intersecting? If I try to click the surface of section view it will adjust the view and can not measure anything…
-
Improvements to Onshape - June 1st, 2021
Let’s kick things off in June with a new Onshape release - this time with a big focus on drawings! Let’s take a look! GENERAL IMPROVEMENTS CHANGE THE LOCATION OF A DOCUMENT FROM WITHIN THE DOCUMENT To move an entire document to another project or folder, it is now also possible to do this directly in a document without…
-
Section view missing
Hello, I can't find anymore section view option in the camera and render options drop down menu. Where it is moved?
-
Broken-out section view arrows
How do I get the section cutting line and arrows of a broken-out section view in its parent view?
-
100 mm Cube with 40 mm Hole
This is the second project I have my students do. The goal is to make a part that matches the drawing. Students submit a PDF of their drawing file and share their design with me when done. The drawing should be dimensioned to match the model provided. At this point students have seen the Extrude tool, but they have not…
-
Filling in section view
Hi, I'll try to be specific... I'm designing a component that's to be fitted in a concrete structure. To illustrate what this will look like, I mock up the concrete structure in a part studio and fit my steel part and concrete in an assembly. Then I create a drawing of the assembly with a section view. The problem now is…
-
Section view of only specific parts in an assembly
Is it possible to create a section view of only some parts in an assembly? For instance, how the cutaway view below cuts through the engine block but not the pistons, valves, crankshaft, etc. Thanks you
-
Section view is not showing the internals of the view
I've taken a section view through a model that I have made. I was expecting to see the internals of the model with hatched lines on the cut sections - a standard section view. However, the section view is showing the end of the model with no internal detail. The section view is in the correct place on the parent view. I'm…
-
Making a detail view of a section view
I can't seem to make a detail view of a section view on a drawing. Is this not supported. Further to that, is it possible to edit the shape of the detail view to make it something other than a circle? I use this on every drawing I do at work.
-
Interference in a Hinge
Is there a command in Onshape that will help me find interference in a hinge? It's probably obvious but section view seems to be the only option I can find.