sketch plane

I am currently working on this part. The idea that I'm trying to make work is for the end of the gray part to be parallel to the face of the blue part as the angle of the blue part changes. I made a plane parallel to the blue part's face and drew the sketch on it. It looked good until the angle rotated past 135 degrees.…

I am trying to create a hole at this place for a while, but I am not able to create a plane at that particular place to create a thorough all hole, not sure what is the best way to do this. I am pretty new to Onshape, so any help here would be useful. This is my document,…

Hi! I'm basically a complete Onshape beginner, so please bare and be patient with me. I am trying to create a tape dispenser (pic) in onshape, right now working on the body. I've managed to make the bottom part of the body, on which it can already be seen that the front and back have different widths, and the bottom and…

When I create a sketch on sheet metal, I try to select the face of the part as the sketch plane, but a face of a previous feature, usually a hole, gets selected. This is annoying because I lose subsequent sketch planes when I edit features. I end up having to sketch on one of the coordinate system planes to make my…

Hello, I don't speak chinese.. Can somebody translate this error message @skSolve: Parent Id FovTflfcvumxF3Q_0.sketch_ used at two non-contiguous points in operation history (Cannot have FovTflfcvumxF3Q_0.1.1 between FovTflfcvumxF3Q_0.sketch_.1 and FovTflfcvumxF3Q_0.sketch_.2)

I often make a few sketches on the same plane, with features from the previous sketches used as reference. Each sketch needs a plane specified, but I'd prefer specifying the first sketch-- to use its plane-- for subsequent sketches I want there. The need to specify the plane on the second and third sketches independently…

I am finding myself at times needing to have a sketch plane where no convenient face exists. I have been doing a cumbersome work around by creating a cube, then transforming to the correct location and orientation and then starting a sketch with the face of the cube as my sketch plan. This feels very cumbersome. Is there a…

Hello, Is there a way to edit or move a sketch plane, without deleting that sketch and starting over? Being new to the program, I selected a sketch plane, on a existing extrude, drew a sketch, then went to extrude (remove) a section. Since the program does not have extrude in 2 directions, I can remove material from either…