splines

I made a cutout of an airfoil and want to move it forward about 7mm from where it started to make space for a leading edge slat that I am attempting to create. I am currently copy and pasting the sketch, re-aligning it to it's original position, then moving it forwards, but the cut-out section of the airfoil keeps on…

I'm trying to remove drawer edges and I'm wanting to do a linear pattern in the sketch. Would this process be better done at the feature level?

Hello. I am relatively new to 3D modeling but have been using OnShape to make designs for 3D printing for about a year. I understand most of the basics of sketches and extrusions and have played around with revolves, lofts, sweeps etc. One thing I would like to get better at is remixing designs. To that point I have…

I was having issues creating smooth lofts on this helmet. https://cad.onshape.com/documents/b2f8fe08679dabeeac1950da/w/17ab1e761096c9e8b822b024/e/0182e42400e098613859acbe After 3dprinting it I determined I need to resize the helmet a bit so I decided to redo the base sketches use Bézier curves instead of splines. Which you…

Does anyone out there use the Sketch Spline Tool? Basically, I think it is an unusable tool. Its behavior appears unpredictable and genuinely unproductive. Am I missing something? For example, if one were to adjust a section of a curve, it will affect other areas. This makes no sense to me. (I think it may be time for…

Greetings, Recently I've been doing a fair bit of experimentation with splines in Onshape, and in the process I've written a small treatise on my blog about splines, B-splines, offset curves, etc., together with some code examples in FeatureScript. If you've been puzzled by skFitSpline(), opFitSpline(),…