subassemblies

In the top level, I have this. The Linear Pattern 1 is highlighted. When I hover, it says "Mate overdefines the assembly". In the subassembly, all is well. How do I troubleshoot which mate is a problem in the top level, as specified in the error message? Here are the top level mates. Here is a link to the model.…

Two Questions Relating to BOMs and Drawings: I have a multi-level BOM I want to display on a drawing that overflows the 8x11 page I'm using as my drawing template. Is there a way to paginate this BOM so I can break it up into 2 drawings? Or a way to filter just certain levels? See below: If I create a drawing of a top…

I have a subassembly with a revolute mate which has limits of +/- 45deg defined (see animated gif). When this is inserted in a higher level assembly, all of the limits are no longer viable and everything acts like a fastened mate in whatever the last position was when the version was created. Is this expected behavior?…

In the image below I've highlighted 2 subassemblies, I want to get all if the parts from the 2 subassemblies into 1 subassembly. Ideally the top one but at this point I'm frustrated enough not to care. The assembly Drive Train is a separate doc inserted into the top level doc that Cooling system is a subassembly in. So far…

How do I get a subassembly to update in another assembly? I'm somewhat new to Onshape so I'm thinking I must just be missing something? Here is the link to the document: https://cad.onshape.com/documents/0972c60bd97f846dd45ef552/w/0b8a3bba54a2f379908deb3e/e/eae8273619aef6653973b63c I want the assembly "Mezzanine Main…