Tube

Hi, I’m a complete beginner and could use some help here. There need to be three locking tabs 120° at the end of the tube (like a bayonet mount), but unfortunately, I can't create a sketch on the curved surface to draw the profile and then cut it out. Does anyone have any ideas?…

I need to work with section of steel tubes witch are not available on the list in the "Tube " tool. many thanks michel

I have two lofts that I have created with loft thin command , one from the left curved to a center hole, and one from the right curved to that same center hole. I need to remove the parts inside them so that the inside of the "Y" shaped tube they create is hollow. Not sure the best way to go about this. Or, is there a…

Hi all, I am trying to make a hose with a 3d fit spline, so it curves in all 3 dimensions. Now I am trying to add a helix to the outside to create a sweep path for an external profile. The helix tool does not allow this, is there a way to make it work and how? UPDATE, I found 3d spiral feature script, works a treat.

I am trying to model the S-bent tube from this drawing : I tried to first define the bend path and made some profile along the way to connect with a loft function without success. I thinking it would be easier to first make the straight tube and then apply the bending but I don't know which feature to use. I tried with…

I have successfully created pins and sockets on tube joints, however i cant find a way to prevent the sockets from extending right through the far wall of the second tube. See example https://cad.onshape.com/documents/7b1fcf924bc3bd3b89b96777/w/702e3f28adb5dedf3c2d04c3/e/bc9a81099715333be1df8ed5 am i overlooking something?