versions

Hello! I'm looking for any feature script which can give me back the name of the version where I'm working in. The reason for this is the following one: I want to assign a customize part propertie where the part number contain the version name, so I need to achive the document version to add in a variable. Thanks!

I have done much additional work before I realized a folder I created that held 26 sketches was empty. I can go back in history to that restore point, but in doing so, I lose all work since. I can't see how to simply undo that deletion and bring all those sketches back into my Main document. I created a version just before…

Is it not possible to roll back to an older version of a linked document? I had an assembly with linked documents that I wanted to do some drawings, part way through the design so I created versions in all of them. Later after making a lot more changes and without thinking I went through and updated everything to the…

I'm still trying to figure out some of the sharing privileges with versioning. I was recently giving a demo with GTol, and I wanted to share the V3 level, but as soon as I changed my version, their version changed too. That's fine. Here's my work around. I created my start part, with a version marked where I wanted the…

First of all a disclaimer. I'm a hobbyist engineer by night and a software developer by day (sadly these days in management, but the mindset stays). So on the basis of 'if the only tool you have is a hammer..', I've probably approached my onshape use in an odd way. I'm designing a steam engine which is in this document.…

hello, up until now, I had used onshape versions, but not branches. since I need a version of the part that fits a clients special requirement, I made a branch and edited it to spec. I find the icons at the top very confusing and accidentally clicked the create new version button a couple of times when trying to open the…