Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
GregBrown 
Reactions
-
Re: How can I prevent loft twisting, even in a very simple case?
It works really well with a single connection defined, perhaps you missed a pick in defining the connection? Here it is, note I've turned on the Show isocurves which is always a good idea when evalua… (View Post)1 -
Re: Loft Says Self Intersecting Body but I cannot Figure out Why
Just as general observation, I think you're putting a bit too much into each loft… the complexity is pretty extreme when you take this approach. Have a look at the curvature analysis of some of the o… (View Post)1 -
Re: Not sure how to copy this shape
Start with the rectangular block (ear) sticking out of the main body, you don't need those orange, blue, dark grey and light grey bodies. do a full round fillet on each end, do an edge fillet with ra… (View Post)1 -
Re: Warning and Issue with Two Co-linear Opposing Tapped Holes
Did you try it with a counterbore holes instead of separate features for the shoulder cutouts? If you're seeing an error you should submit a support ticket. (View Post)1 -
Re: Routing curve & Control point curve - Introduction of two new features for 3D curve creation
Another update to the feature today… When Approximating spline edges there is a option to Show deviation. A marker is added to the display as well as an information bubble. Note: Depending on the cur… (View Post)2
