Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
GregBrown 
Reactions
-
Re: Can't subtract derived part but don't know why
When you are trying to "Offset all", you are automatically including a LOT of faces that really have no impact on the cutout, except of course to mess it up. If you just do the Boolean subt… (View Post)1 -
Re: Connect face to angled curved surface
Face blend with hold line (View Post)1 -
Re: Routing curve & Control point curve - Introduction of two new features for 3D curve creation
Jonathan, thanks for the feedback and continued interest in this feature… Firstly, how many points are in your Routing curve array? Does it become too laggy after a certain number of them, or is your… (View Post)1 -
Re: How to prevent unintended/undesired constraints
If you keep the shift key pressed while placing a sketch element then the automatic constraint inferences will be ignored. (View Post)3 -
Re: Thicken failure
Zoom right in on the end of the spline in that sketch (View Post)1
