Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
MDesign ✭✭✭
Reactions
-
Re: Why are .dxf import sketch points broken?
imported geometry never assumes constraints. Arguably assuming certain constraints should be supported. I’ve not seen issues with dxf such as you describe. Can you share a link to your document? (View Post)1 -
Re: Help with Complex "Fillet"
variable fillet is probably what your looking for. (View Post)1 -
Re: Constraining two sets of circles with a common midpoint
eric's suggestion is good but if you want one less line… draw a vertical construction line between the circles. set each circle on one side with a mirror constraint to the other side. (View Post)2 -
Re: Cannot select entire circle to extrude cut
Work ok for me. perhaps you need to utilize'select other' (or turn off your part temporarily for selection purposes) and change the starting offset or some other variation of the extrude feature prop… (View Post)1 -
Re: Tangent connector
A peak behind the magician's curtain. (View Post)1
