Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Smith EDU
Here is a list of a few interesting things about me:
-
-
-
Reactions
-
Re: Dimension an Arc length in Drawing
I do not believe there is a way to do so in a drawing. When you are in a part studio, using the dimension tool, you can select the two end points and then the arc to figure out its length. However, w… (View Post)6 -
Re: Creating offset shaped extrusions
You could try using the revolute tool and then shell out the inside of it when you're done. Here's two screenshots of a rough draft I did: Hope this helps, Ethan (View Post)1
