Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
david_lang457 ✭✭✭
Reactions
-
variable studio improvements
Is there a way to import into a variable studio (from a csv or similar)? It would also be nice if it was possible to create a table. I'm doing work where I am using different steppers and while I can… (View Post)1 -
Re: is there a way to highlight what isn't contained in a sketch?
Would it be possible, to highlight only the conflicting constraints in an overdefined sketch, instead of all the sketch? That would make troubleshooting a bit easier, too. It's a lot hard than it see… (View Post)2 -
Re: is there a way to highlight what isn't contained in a sketch?
I finally found a point that wasn't constrained, it would be good to add some way to make such things more obvious. (a way to pulse a circle around a problem, or just blink the unconstrained componen… (View Post)1 -
Re: Dogbone and Corner Overcut Features for CNC router design
Thanks for this, the corner overcut is exactly what I've been looking for. I would suggest that in the case where the angle is <90 degrees, the corner overcut should have straight-walled sides (or… (View Post)1 -
feature request, text notes tab
yes, you can work around this by doing a drawing and making big text boxes or similar, but I was realizing that I wanted to add a bunch of notes, hyperlinks, etc to a document (house plans, listing q… (View Post)2
