Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
jakeramsley 
Reactions
-
Re: Merge available?
There should be a history entry on the branch that had main pulled into it that says something like 'Merge from Main'. If you select the entry just before it and chose 'Restore', the merge effective… (View Post)1 -
Re: Extrude-Remove-Offset from Surface to retain wall thickness?
I would do it as a blind then change the terminating face using a replace face with an offset. 1. Start with a small blind remove extrude to get the start of the faces you want to remove. 2. Start a … (View Post)6 -
Re: New to parametrics: how do I make a basic cube controlled by one dimensional value?
I would use a sweep with the system as is. 1. Sketch a center-point rectangle and make the lengths equal to be a square. Dimension the square, this will be the dimension to drive the cube size. 2. On… (View Post)7 -
Re: Measuring Imported Files
Measurement is always on and based on your current selection. Measurement is shown in the bottom right corner of the screen. Hovering over specific measurements will show graphical representation of … (View Post)1 -
Re: Need help with mates and gear relation please
Make revolute mates with respect to the origin. Make two explicit mate connectors, one that is at the origin and one that is offset in one direction by (D1 + D2) / 2. From here, make the revolutes wi… (View Post)2
