Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
jakeramsley 
Reactions
-
Re: What are your top 10 most commonly used materials?
Mass properties to start with. (View Post)1 -
Re: Hollow Part?
Hollow should be available soon. In the meantime, my preferred method is to do a thicken + intersect. 1. Model the part you want to hollow. 2. Start a thicken and set it to intersect. Set the thickne… (View Post)6 -
Re: Merge available?
There should be a history entry on the branch that had main pulled into it that says something like 'Merge from Main'. If you select the entry just before it and chose 'Restore', the merge effective… (View Post)1 -
Re: Extrude-Remove-Offset from Surface to retain wall thickness?
I would do it as a blind then change the terminating face using a replace face with an offset. 1. Start with a small blind remove extrude to get the start of the faces you want to remove. 2. Start a … (View Post)6 -
Re: New to parametrics: how do I make a basic cube controlled by one dimensional value?
I would use a sweep with the system as is. 1. Sketch a center-point rectangle and make the lengths equal to be a square. Dimension the square, this will be the dimension to drive the cube size. 2. On… (View Post)7
