Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.First time visiting? Here are some places to start:
- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
Mechanical Design Engineer
- Last Active
- Member, Developers
I'm not too familiar with the Compare tool. But an alternative is to perform a boolean subtract of one body from the other. If there are any differences, they will show up as a separate part in the p… (View Post)1
(Quote) Personally, I prefer enforcing units. It's less flexible in some ways, but if done properly it saves a lot of hassle downstream. It just requires a little forethought. Scaling factor… (View Post)3
@jonathan_yu202 You should definitely check out the tutorials. It will minimize the stumbling over fundamental CAD topics. Also, check out Forum Post Checklist. #4 in that post is going over the free… (View Post)2
It took some doing, but here's my take using a loft with 2 guide curves. The guide curves were created via the Contour Spiral FS. https://cad.onshape.com/documents/57acdfaae4b005c413ed9b6f/w/3fd585a4… (View Post)2
@Barry_van_Wijk You can use the spiral FS above to create a curve that rotates around your main sweep path. That curve can then be used as a guide curve, which will rotate your profile sketch as it f… (View Post)1