Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
scott_willis165 ✭✭
Embedded systems engineer with eclectic DIY interests.
Reactions
-
Re: Way to measure volume?
Sorry, that was not clear: trying to measure the volume of a conical opening. Actually a combination of a cylindrical opening plus a conical tip. However I could use the Mass Properties tool after cr… (View Post)1 -
More informative error messages?
When entering a formula, it would be very helpful to have more informative error messages, including e.g.: * "Units mismatch, expected length found mm^3" * For an invalid parameter, *WHICH*… (View Post)1 -
Re: Angle constraint in sketch mode
2:04 in https://learn.onshape.com/learn/course/fundamentals-sketching/sketch-constraints/dimensions. (View Post)1