Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Imported DXF
frank_ring
Member Posts: 42 ✭✭
in Drawings
After importing a DXF file I want to extrude this geometry into onshape.
The drawing is not recognized as closed geometry. What can I do to find the "open" point.
Thanks for your support!
Frank
Frank
.
0
Comments
this was covered here. https://forum.onshape.com/discussion/comment/59496#Comment_59496
With my solution, I would have follow all lines with high magnification - tedious