Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Square Spring?
jason_traud
Member Posts: 15 ✭
in General
Is it possible to make a square spring? I'm attempting to make the Keystone 5016 test point linked below.
https://www.digikey.com/product-detail/en/keystone-electronics/5016/36-5016TR-ND/278887
I had originally tried to make a standard spring and then subtract out a square center and a squared exterior but the result is a bit wavy.
https://www.digikey.com/product-detail/en/keystone-electronics/5016/36-5016TR-ND/278887
I had originally tried to make a standard spring and then subtract out a square center and a squared exterior but the result is a bit wavy.
0
Comments