Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Kiri moto & Onshape
patrick_shea
Member Posts: 63 EDU
in General
I am new to all this, so making some simple shapes, and exporting through Kiri to our Romaxx Router table. I am using some pre cut blanks (5 x 7), and just wanting two pockets & slots done, not the perimeter. Here is an image, hope it makes sense.
0