Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
sheet metal flanges
Trying to make a flange bend in opposite direction to existing. Not having much joy.
I see bend relief gets consumed which is not wanted.
Flange is offset to outside existing bend when using flange alignment inner and when switched to outer a gap is left behind.
Any thought on how to accomplish this would be much appreciated.
Glen D
https://cad.onshape.com/documents/217c268e2a134cee82d912e7/w/4aa25909fa4c1ddccad009b7/e/004f80cbd3275a5b683a967c
I see bend relief gets consumed which is not wanted.
Flange is offset to outside existing bend when using flange alignment inner and when switched to outer a gap is left behind.
Any thought on how to accomplish this would be much appreciated.
Glen D
https://cad.onshape.com/documents/217c268e2a134cee82d912e7/w/4aa25909fa4c1ddccad009b7/e/004f80cbd3275a5b683a967c
0
Comments
Manual bend relief would give you a better behavior.
https://cad.onshape.com/documents/92d612152064f3f92b68a475/w/803258626ec762ea1e03ba80/e/16e0558fef2e19e830f133d0
Got a note from Tim@OS that this is on the fix list.
Glen