Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Angle Mate
Ralph_Hamilton
Member Posts: 9 EDU
I really think you need to establish an Angle Mate. As far as I can figure, there is no way to reference two edges or faces in an assembly and set them at an angle.
Tagged:
0
Comments