Some questions about assemblies and mates

adam_mercier

Hello There, I have some issues with an assembly Im working on , I cant find how to make a linear constraint between two mates origins. Is that even possible?

Best regards, Adam

nav

Hi @adam_mercier you first need to realign either of your mate connectors then use fastened mate with offset.

andrew_troup

@adam_mercier 
@nav suggests just what I would have, but with a lot less words  (he could give master classes in how to be concise)

To get a quick insight into how to reorient mate connectors, you might check out this clip
https://www.onshape.com/cad-blog/tech-tip-mate-connectors-in-onshape
starting at 1:24

nav

andrew_troup said:

@nav suggests just what I would have, but with a lot less words  (he could give master classes in how to be concise)

jajajaja Andrew I wished, thanks for your kind words.

shanshan