Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Join surfaces
farnesi_alessandro
Member Posts: 2 ✭
in General
Good evening everyone, I'm asking for your help to solve a problem that is impossible for me. I've just started and I'm getting into very big difficulties. I would like to join surfaces, the corner of the box, where I attempted a sweep. Can you show me the right way?
Thanks, I hope I'm not bothered with this discussion.
Thanks, I hope I'm not bothered with this discussion.
0
Comments