Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Add fillet capability to sheet metal bend reliefs
Connor_LeCLaire
Member Posts: 33 PRO
in General
Hello,
I have recently forayed into sheet metal design and noticed that I cannot add a fillet to a sheet metal bend relief (see image). I can understand why in some cases it would be undesirable, but in this case, I think it would be fine. I currently have to manually sketch and extrude a tangent arc to accomplish the same result.
I have recently forayed into sheet metal design and noticed that I cannot add a fillet to a sheet metal bend relief (see image). I can understand why in some cases it would be undesirable, but in this case, I think it would be fine. I currently have to manually sketch and extrude a tangent arc to accomplish the same result.
3
Comments