Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
A few newby questions about simulation
dave_franchino
Member Posts: 52 ✭✭
in Simulation
Hey folks,
I'd like to try to simulate a progressive coil spring in Onshape (tapering diameter and changing coil pitch). Making this even a bit more complicated - some of the coils lock up during the actuation. This might be beyond Onshape - but a couple of questions.
A) I recall that when I used the simulation module in Soldworks they had a "large displacement" mode for situations where there was.... well... large displacement. Does such a mode exist in onshape?
Is there a way to prevent "penetration" ideally between a part and itself - but if not, between multiple parts?
Thanks!
I'd like to try to simulate a progressive coil spring in Onshape (tapering diameter and changing coil pitch). Making this even a bit more complicated - some of the coils lock up during the actuation. This might be beyond Onshape - but a couple of questions.
A) I recall that when I used the simulation module in Soldworks they had a "large displacement" mode for situations where there was.... well... large displacement. Does such a mode exist in onshape?
Is there a way to prevent "penetration" ideally between a part and itself - but if not, between multiple parts? Thanks!
0