Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Issue with intersection of two extrusions that has an odd angle
dan_bernskoetter
Member Posts: 2 ✭
I have the intersection of two perpendicular extrusions that does not match up properly and I get small piece of filament when printing that does allow another part to slide into the extrusions.
0
Comments