Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Angled hole

in General
Hello, I have a project that requires an angeld hole with a line in it to hold a SMA port with an interupted thread (part of it is flat). I have only seen documentation here on how to do a full on circle cut out. Could anyone plese tell me how to make this hole?
Thanks,
Miles
0
Comments
Use a mate connector for your sketch plane. Then angle the mate connector.
This worked perfectly. Thanks so much