Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Unable to load DXF into Sketch plane
steve_williams305
Member Posts: 4 ✭
in General
Hi, I have imported a DXF from Makercase. The file uploads fine but when i click on it to put it won't load into the Sketch plane. Any help is appreciated. Thanks
0
Comments
Perhaps it loaded but you need to zoom way out?
I managed to figure this out now. I needed to hit the green accept arrow. D'oh. The idea is to get complex shapes out of Solid Edge into both OnShape and also Lightburn with exactly the same dimensions and profile. So success. Yeah!
yes all kinds of tricks and special protocol for lots of stuff….and considering the way this is growing in features it may be a long time before inputs are standardized across the platform….but I should not complain the free public platform is a big money saver