Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
addind a taper to design
israel_andrade
Member Posts: 1 ✭
in Drawings
I have a design in mind that is a thickened tube but I need to taper it to a smaller outside diameter on one side. I am new to this and have watched the videos. but have not seen a taper done. Please advise.
Israel
Israel
0