Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
OPENBOM with Onshape
brian_pinder662
Member Posts: 119 ✭✭
in General
Don't know if I am in the right place for this advice but maybe someone can help. I have an assembly with certain parts in multiples of six all exactly the same and would like to show them in the BOM as quantity col as 6 . at the moment each one is shown in the thumbnail in its 3D orientation as quantity 1.As you can imagine this takes up quite some space. I have tried several ways to make this work without success. Can anyone say if this can be done. Any help would be appreciated as my drawing sheets give me limited room. Best Regards Brian.
0
Comments
Did you model all the parts separately (showing as multiple parts in the part studio)?
IR for AS/NZS 1100
Hello Brian,
I can help. Please write me to oleg @ openbom dot com.
Also , please share your assembly with Onshape (!!) account - support @ openbom.com.
We will take a look asap
Best, Oleg
OpenBOM CEO and co-founder.