Home› General

Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Closing mate connector edit window in sketch leaves "Sketch plane" field in focus = bad

vanowmvanowm Member Posts: 111 ✭✭
in General

Hello.

When adjusting a mate connector for "Sketch plane", closing the window and clicking on existing part, plane, origin etc will replace the selected mate connector. This is quiet annoying behavior.

OnShape Sketch Plane.gif
https://greasyfork.org/en/scripts/522636-onshape-helper
Tagged:

Comments

  • S1monS1mon Member Posts: 3,745 PRO

    Agreed. It would be much better if the focus switched to the sketch instead. I've had this experience more times than I would care to say.

    Simon Gatrall | Product Development Specialist | Open For Work

  • MDesignMDesign Member Posts: 1,258 PRO

    Agreed^2

Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. Sign in or register to get started.

Sign In

Categories

Vanilla Forums