Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
Sweep angle to face
christopher_browne008
Member Posts: 2 ✭
Good day everyone,
I am novice designer and have been trying to learn Onshape since I graduated from undergrad. My first self project was to recreate a simple distillation apparatus. However I am having some issue, trying to create the condenser part. The condenser should pierce through the cylinder until the inner wall. However I am not sure how I can accomplish this. I have tried using the loft feature and that works but I am not sure how to specify the end point of the inner face of the cylinder.
I am attached the link to the file and an image for reference:
The highlighted area of the inner cylinder is where I would like the loft to end. However I am not sure how to accomplish this.
Link : https://cad.onshape.com/documents/ffbc4ee1f8b5a62536a9f2b9/w/d607303f8f756b7b4f33ac56/e/a64fa9307d95ceca25c25a02?renderMode=0&uiState=6988c7049d72368904c9c163
Any guidance offered would be appreciated.
Answers
Have a look at this and see if will help.
https://learn.onshape.com/?hostDomain=cad