Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.

First time visiting? Here are some places to start:
  1. Looking for a certain topic? Check out the categories filter or use Search (upper right).
  2. Need support? Ask a question to our Community Support category.
  3. Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
  4. Be respectful, on topic and if you see a problem, Flag it.

If you would like to contact our Community Manager personally, feel free to send a private message or an email.

Drawing Problem

brian_pinder662brian_pinder662 Member Posts: 119 ✭✭
edited November 2018 in Community Support
Can anyone give any help as to why I am not able to dimension this drawing any further. the centre point circle not working, also cannot dimension large rad.
Previous drgs have been fine. regards Brian.

Best Answer


  • brian_pinder662brian_pinder662 Member Posts: 119 ✭✭
    Thanks for your interest Chris however managed to find the problem. It was due to an error in the part studio that I had been modelling top down. I would have willingly shared a link but the problem is no longer there but thanks again 
Sign In or Register to comment.