Under Review

One downside of the constant flow of additional features to OnShape is the featurescript documentation gets somewhat left behind. Sometime I discover something by chance (or by close study of the std features source code) and would love to be able to share that knowledge in a structured way. For example I found today that…

Sketches are the foundation of any drawing and they are so powerful. Why? Because they allow to fix only some dimension while the others are evaluated (by OnShape) accordingly, depending on constraints! This is how I do sketches. And this is how it should be done, I think. However, this is not possible with FeatureScript,…

the default sketch fillet radius is 5. If you try to fillet something very small, It tries to start with the fillet at the 5mm default, but it cannot, and it cancels the fillet, giving the error: The current fillet radius produces invalid geometry. Since it exits out of the fillet tool before you can even change the radius…

When trying to get a diagonal dimension from corner to corner in drawings, it keeps jumping from vertical to horizontal. So the only solution I have found is to draw a construction line from corner to corner. Then dimension the line. Thanks

During a project I was needing to measure a distance into the assembly ambient and I noticed that the measuring tool doesn't function as in the part studio: why?? I haven't been able to make the measure, I had to go to part studio, not the best in my opinion.