hole tool

How do you display thread lines in a part studio? I'd like dotted lines to identify this as a tapped hole, and it would be a better representation of the hole. Thanks!

Workspace in question: https://cad.onshape.com/documents/271f21901617d414379deeff/w/cd5ff1694f30cd815e7a7fa2/e/733c305ecad3fb11e6906bf2?configuration=AR%3D3.5%3BRibCount%3D4.0%3BS%3D4.5%3BTR%3D0.6&renderMode=0&uiState=6760e71a37f4be1332ee59be "Linear pattern 5" includes, among other features, "Mate connector 2" and "3.2 mm…

I have been tasked with designing a new tap (faucet) handle and then 3D print a set for the bathroom. At some stage it will need to fit to the internal ceramic cartridge but for the moment the method of producing hole that fits over the arrowed part [1] is eluding me. Is there somewhere a tool that I can use? I have looked…

I use a lot of M3 heat-set threaded inserts in my 3Dprints but it takes several hole operations to generate the type of geometry I need. I haven't really created a featurescript before, but I think this would be a good use-case to simplify my workflow. What I'd like is to be able to specify a somewhat complicated hole type…

I have a part that is .500 thick and a hole that is supposed to go .400 into the part. I am using the hole tool with a 118 degree drill specified. The little diagram on the picture seems to show that it is using the entire drill depth but my drawing seems to show the drill point VERY close to the lower surface. This would…