plane

So I see that the tangent plane feature seems to only work with cylinders which seems quite limited. I would love to get a tangent plane to a general curved surface. It seems like if I make a minimum bounding cylinder, make the plane around that, then suppress that part I could get the desired plane, but I also cannot…

Is there an efficient way to query all bodies on one side of a plane?

If I draw a rectangle on the front plane, and extrude it by 100mm.. Then rotate my view and start sketching on the right plane.. It's like the sketch tools don't acknowledged that there's now an object, edge, or line there. I need it to 'snap to' so I can place some lines and holes in the right spots, relative to the…

I'm trying to place a plane consistently on multiple types of faces to use in a transform. I can get a plane that is normal to the selected face, but I keep getting stuck. The plane needs the following conditions: * Origin: middle of selected curve/edge. * Normal: same direction as curve/edge. * X-axis: always facing…

How can i tilt the axis of a plane? I want to sketch on, and extrude from slanted surface. See how it's not lining up?

I have created a plane (that is not parallel to the default planes like front etc. ) and created an part as an extrude from a sketch on that plane. Now I would like to create a drawing that is based on that drawing. I selected the part and picked the menu Create Drawing from part. I tried to select another plane then…

I created 2 semi circles on two parallel planes that are offset from eachother. I then created another plane across the flat sides of the Semi circles and im trying to sketch 2 lines from the outer points of the semi circles down that perpendicular plane. but the tool wont snap to the outer points, it will only snap to the…