Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
MDesign ✭✭✭
Reactions
-
Re: Scaling an imported image
This is a known pro tip not sure who gets the credit. but you can't have any other dimensions or contraints in the sketch. create a seperate sketch for each image you want to use. (View Post)1 -
Re: Holes Around a Spiral
In this case you will need to do the holes in flat pattern view, and utilize sketch patterns. It seems there's a limit of 100 for sketch patterns and I had to use 3 patterns to get enough holes. Prob… (View Post)1 -
Re: Consultation on how to create a sweep between two parts in different plains
You might find loft with a path helpful. but you may need to add an additional profile or 2 at strategic locations to control the tilt that will be inevivtable when it joins the ball tray at the bott… (View Post)1 -
Re: How to correct this notice: "sketch is not fully defined"?
@trenton_haynes631 You can design without fully defined sketches. You risk unexpected behavior after the undefined sketch if you make changes prior to the undefined sketch in the feature tree. (View Post)1 -
Re: Can you make a configurations table via CSV?
@MichaelPascoe You just have to create single junk line then ctrl+v in the first cell. (View Post)2
