Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
ProblemSolver ✭
Aged 70+ Pensioner. With 3D Printer and Arduino experience.
MOTTO: These days, NOTHING IS IMPOSSIBLE....
About
- Username
- ProblemSolver
- Joined
- Visits
- 57
- Last Active
- Roles
- Member
- Points
- 10
- Badges
- 2
- Posts
- 12
Reactions
-
Re: Applying Linear Pattern to inside curved surface
Many thanks again Mahir for your explanation of the problems that you fixed for me. I have been removing some of the highlighted constraints when the sketch title appears in red. From here on I will … (View Post)1 -
Re: Applying Linear Pattern to inside curved surface
Thank you Mahir, this change that you have done achieves exactly what I was after. Thank you so much, I am over the moon with appreciation. Exactly what was the issue, so that I can avoid this proble… (View Post)1 -
Re: Can Construction Lines be placed at the rear of all other lines?
Thanks romeograham, I've only been using Onshape for the last 5 months, and was unaware of this feature. (View Post)1
