Welcome to the Onshape forum! Ask questions and join in the discussions about everything Onshape.
First time visiting? Here are some places to start:- Looking for a certain topic? Check out the categories filter or use Search (upper right).
- Need support? Ask a question to our Community Support category.
- Please submit support tickets for bugs but you can request improvements in the Product Feedback category.
- Be respectful, on topic and if you see a problem, Flag it.
If you would like to contact our Community Manager personally, feel free to send a private message or an email.
-
Re: How to get Midsurface for part?
Midplane option of the plane feature will work fine if you just want to get a plane in between two planar surfaces. If you want a middle surface for the entire part you'll need to use Offset with a v… (View Post)-1 -
Re: Is it possible to create an non horizontal/vertical (angled) ordinate dimension?
I never had a need for this, but no. It doesn't seem like this is possible. Even if you rotate the view, ordinate dimensions remain horizontal/vertical. Sounds like a good candidate for an improvemen… (View Post)0 -
Re: angleBetween with a reference
Interesting problem. I took a look under the hood, and this is how angleBetween(vector1, vector2, ref) is calculating the angle. I don't get the vector math, but it is what it is. var dotProd = dot(v… (View Post)-1 -
Re: How do you curve the point on a cone? I don't like how sharp/pointed the
Lots of ways. The first two that come to mind are to build the round tip into the sketch used with a revolve. Another way is to cut the tip off and apply a fillet. But a lot of these questions you ha… (View Post)1 -
Re: Why is not possible to change the rotation angle of the initial (principle) drawing view?
Two years later :D (View Post)0
